Guide Odin Flash / Update firmware ODIN

Guide Odin Flash / Update firmware ODIN

• You do not need to root or unroot the device to update the firmware.
• Please ensure that KIES is closed and not running in the system tray!

0. Download and Install: Samsung USB Drivers 1.5.51.0 and ODIN
1. Just download the firmware version you want from this posts and extract the .tar or .tar.md5 file in the archive and save it somewhere.
2. Reboot your phone to download mode. To get download mode shut down the device. After it shuts off completely simultaneously press the Down volume key+ Home button + press the power button .
You should see a warning asking you to press volume up if you want to continue or volume down to cancel, press volume up. You are now in download mode!
3. Start Odin 3.**

• If your ROM is a single .tar.md5 package click on the AP/PDA button and browse to the .tar or .tar.md5 file that you extracted in step 1 and select it.
• If the package has more than one .tar archive then they will be labelled with PDA/Code, Phone/Modem and CSC. Just put them in the corresponding section of Odin like below
  BL = Bootloader
  AP = PDA (CODE)
  CP = PHONE (MODEM)
  CSC = CSC

4. DO NOT PUT .PIT FILE AND DO NOT, I REPEAT, DO NOT TICK REPARTITION.
5. Connect the USB cable and wait for any required drivers to install and the ID:COM section to turn blue like below.
6. Click start to flash.
7. Do not disconnect the cable or turn off the device once the flash has started, it will reboot when it finishes.

*Note PDA/AP/CSC/CO/MODEM/etc